User guide

Configuring filtering rules for a WM-AD
Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide
125
3 Click the Filtering tab.
4 From the Filter ID drop-down list, select Exception.
5 For each filtering rule you are defining, do the following:
● In the IP/subnet:port box, type the destination IP address. You can also specify an IP range, a
port designation, or a port range on that IP address.
● In the Protocol drop-down list, select the applicable protocol. The default is N/A.
6 Define a rule to allow access to the default gateway for this WM-AD:
● Select IP/Port.
● Type the default gateway IP address (WM-AD's IP address) that you defined in the Topol og y tab
for this WM-AD.
7 Click Add. The information is displayed in the Filter Rules section of the tab.
8 Select the new filter, then select the Allow checkbox applicable to the rule you defined.
9 Edit the order of a filter by selecting the filter and clicking the Up and Down buttons. The filtering
rules are executed in the order you define here.
10 To save your changes, click Save.
NOTE
For external Captive Portal, you need to add an external server to a non-authentication filter.