Installation guide

Summit Switch Hardware Installation Guide 1-27
Summit1i, Summit5i, Summit7i, and Summit48i Switch LEDs
Reset Button
The reset button is used to hard reset the switch. Use a non-conductive tool to push the
reset button.
Console Port
The console port (9-pin, “D” type connector) is used for connecting a terminal and
carrying out local management.
Summit1i, Summit5i, Summit7i, and Summit48i
Switch LEDs
Table 1-5 describes the light emitting diode (LED) behavior on the Summit1i, Summit5i,
Summit7i, and Summit48i switches.
Table 1-5: Summit1i, Summit5i, Summit7i, and Summit48i Switch LED Behavior
Unit Status LEDs
LED Color Indicates
Power
(A and B)
Green
Yellow
Green/Yellow
Flashing
Off
The indicated power supply unit (PSU) is powered up.
The indicated PSU has a failure.
The AC power cord is not inserted correctly.
The PSU is not receiving power or no PSU is present.
MGMT Green flashing
■ Slow
■ Fast
Yellow
The switch is operating normally.
Power On Self Test (POST) or software download in progress.
The switch has failed its POST or is experiencing an overheat
or fan failure.