Installation guide

Summit Switch Hardware Installation Guide 1-15
Summit1i Switch Rear View
Both Summit1i switch models also provide two unpopulated GBIC ports with SC
connectors. You can use any of the following GBICs in the Summit1i switch:
• 1000BASE-SX
• 1000BASE-LX
• 1000BASE-LX70
Note: For information on GBICs, refer to “GBIC Type and Hardware/Software
Support,” on page 1-28.
Note: For information on supported media types and distances, refer to
Table 1-2 on page 1-5.
Note: For information on Summit1i switch LEDs, refer to “Summit1i, Summit5i,
Summit7i, and Summit48i Switch LEDs,” on page 1-27.
Summit1i Switch Rear View
Figure 1-8 shows the rear view for the Summit1i switch.
Figure 1-8: Summit1i switch rear view
Power Sockets
The Summit1i switch supports up to two power supplies. Each power supply has its
own power socket. When a second power supply is installed, both provide a redundant,
SHG_Rr1
AC Connectors Console portReset