Installation guide

1-18 Summit Switch Hardware Installation Guide
S
UMMIT
S
WITCH
O
VERVIEW
For information on GBICs, refer to “GBIC Type and Hardware/Software Support,”
on page 1-21.
M
ODULE
R
ESET
B
UTTON
The module reset button is used to hard reset the switch. Use a non-conductive tool to
operate the module reset button.
C
ONSOLE
P
ORT
The console port (9-pin, “D” type connector) is used for connecting a terminal and
carrying out local out-of-band management.
M
ODEM
P
ORT
The modem port is used to connect a modem for remote access to the command line
interface (CLI).
M
ANAGEMENT
P
ORT
The management port (RJ-45 connector) is a 10/100 Mbps Ethernet connection used for
out-of-band management.
PCMCIA S
LOT
The PCMCIA slot is reserved for future use.