User guide

4-12 S
UMMIT
S
WITCH
I
NSTALLATION AND
U
SER
G
UIDE
C
ONFIGURING
P
ORTS
S
UMMIT
V
IRTUAL
C
HASSIS
C
OMMANDS
Ta b le 4 - 9 lists commands that are used on the Summit switch to connect it to a Summit
Virtual Chassis.
C
ONFIGURING THE
S
UMMIT FOR
U
SER WITH THE
S
UMMIT
V
IRTUAL
C
HASSIS
You must configure the Summit switch port(s) prior to connecting the switch to the
Summit Virtual Chassis. Each connected port must be configured as a SummitLink port,
using the following command:
enable summitlink port <portlist>
If you are using a parallel Virtual Chassis stack, you must configure load-sharing on the
Summit after the ports are designated as SummitLink ports. This is done using the
following command:
enable sharing <master port> grouping <portlist>
Table 4-9:
Summit Virtual Chassis Commands
Command Description
show edp Displays connectivity information for neighboring
Summit switches.
enable summitlink port <portlist> Enables the port to connect to a SummitLink port
on the Summit Virtual Chassis. SummitLink cannot
be enabled if multiple STPDs are configured on
the port. The default setting is disabled.
disable summitlink port <portlist> Disables the connection to the SummitLink port on
the Summit Virtual Chassis.
enable edp port <portlist> Enables the generation and processing of Extreme
Discovery Protocol message on one or more ports.
The default setting is enabled.
disable edp port <portlist> Disables the Extreme Discovery Protocol on one or
more ports. EDP cannot be disabled on a port that
has SummitLInk enabled.
Summit.bk : 4PORTS.FM Page 12 Thursday, June 18, 1998 9:27 AM