User guide

8-8 S
UMMIT
S
WITCH
I
NSTALLATION AND
U
SER
G
UIDE
Q
UALITY OF
S
ERVICE
(Q
O
S)
C
ONFIGURING
Q
O
S
Ta b le 8 - 4 describes the commands used to configure QoS.
Table 8-4:
QoS Configuration Commands
Command Description
enable pace Enables recognition of the PACE bit.
Available in ingress mode, only.
create qosprofile <qosname> Creates a QoS profile. The default values
assigned to a created QoS profile are:
■
Minimum bandwidth — 0%
■
Maximum bandwidth — 100%
■
Priority — low
config qosmode [ingress | egress] Changes the QoS mode to ingress mode
or egress mode.
config qosprofile <qosname> {minbw <percent>}
{maxbw <percent>} {priority <level>}
Configures a QoS profile. Specify:
■
minbw
— The minimum bandwidth
percentage guaranteed to be available
to this queue. The default setting is 0.
■
maxbw
— The maximum bandwidth
percentage this queue is permitted to
use. The default setting is 100.
■
priority
— The service priority for
this queue. Settings include low,
medium-low, medium, high. The default
setting is low. Available in egress mode,
only.
config port <portlist> qosprofile <qosname> Allows you to configure one or more ports
to use a particular QoS profile. Available
in ingress mode, only.
config vlan <name> qosprofile <qosname> Allows you to configure a VLAN to use a
particular QoS profile.
disable pace Disables recognition of the PACE bit.
Available in ingress mode, only.
Summit.bk : 8QOS.FM Page 8 Thursday, June 18, 1998 9:27 AM