Installation guide

Installing Summit External Power Supplies
Summit Family Switches Hardware Installation Guide
92
Figure 59: Attaching the Mounting Bracket
c Repeat steps a and b for the other side of the EPS-T2.
4 Slide the EPS-T2 into a 19-inch rack and secure it using appropriate rack-mount screws.
Installing an EPS-150DC Power Supply
NOTE
Install the EPS-T2 before you begin installing the EPS-150DC.
WARNING!
Always be sure that the DC circuit is de-energized before connecting or disconnecting the DC wiring harness at the
DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power
cord between the switch and the EPS-150DC unit.
Installing an EPS-150DC unit consists of the following tasks:
● Connecting the DC wiring harness to the DC source voltage (see page 92).
This task must be performed by a licensed, qualified electrician.
● Installing an EPS-150DC unit in an EPS-T2 (see page 93)
● Connecting the DC wiring harness to the DC power socket on the EPS-150DC (see page 94)
● Connecting the EPS-150DC to a switch (see page 94)
Perform these four tasks in the order they are described.
Connecting the DC Wiring Harness to the DC Source Voltage
The EPS-150DC power module must be connected to a DC power source. A three-wire, 6-foot long DC
wiring harness (Figure 60) is included with the EPS-150DC unit. The DC wiring harness must be
properly connected to the DC source voltage at your facility by a qualified electrician before the
connector on the wiring harness can be attached to the DC power supply socket on the rear of the unit.
See Appendix B, “Technical Specifications” for information about connector pinouts and for DC power
specifications to be used in connecting the wiring harness to the DC source voltage.
ES4K026