Installation guide

Summit Option Cards
Summit Family Switches Hardware Installation Guide
110
To install the Summit XGM2-2xf option card:
1 Disconnect the power from the Summit switch by removing the plug from the wall outlet.
2 If a redundant power supply is in use, disconnect the power of the redundant power supply by
removing the plug from the wall outlet.
3 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the equipment
rack.
4 Remove the screws holding the filler panel over the option slot on the back of the switch (Figure 76).
Remove the filler panel and set it aside. Save the screws for re-use.
Figure 76: Option Slot Filler Panel
5 Align the sheet metal edges on the option card with the card guides in the switch housing. Carefully
slide the Summit XGM2-2xf option card into the switch housing until the connectors engage and the
option card is flush with the back panel of the switch (Figure 77).
Figure 77: Installing the Summit XGM2-2xf Option Card
6 Using the screws from the filler panel, secure the Summit XGM2-2xf option card to the back panel of
the switch.
For instructions on installing or replacing the XFP modules in the Summit XGM2-2xf option card, refer
to the Extreme Networks Pluggable Interface Modules Installation Guide.
ES4K041
Filler Panel
SH_014
Summit Option
Card