Installation guide

Summit Option Cards
Summit Family Switches Hardware Installation Guide
108
Figure 73: Option Slot Filler Panel
5 Align the sheet metal edges on the option card with the card guides in the switch housing. Carefully
slide the Summit XGM2-2xn option card into the switch housing until the connectors engage and the
option card is flush with the back panel of the switch (Figure 74).
Figure 74: Installing the Summit XGM2-2xn Option Card
6 Using the screws from the filler panel, secure the Summit XGM2-2xn option card to the back panel
of the switch.
For instructions on installing or replacing the XENPAK modules in the Summit XGM2-2xn option card,
refer to the Extreme Networks Pluggable Interface Modules Installation Guide.
NOTE
If you install only one XENPAK module in the Summit XGM2-2xn option card, attach the supplied cover plate over
the remaining open module slot.
Summit XGM2-2xf Option Card
The Summit XGM2-2xf option card allows you to add up to two 10-gigabit XFP modules to the
following switches:
● Summit X450a-24t switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450a-24tDC switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450a-24x switch, running ExtremeXOS 11.6.1 (or later)
ES4K041
Filler Panel
SH_013
Summit Option
Card