Installation guide

Summit XGM-2xn Option Card
Summit Family Switches Hardware Installation Guide
105
.
Installing the Summit XGM-2xn Option Card
CAUTION
The Summit XGM-2xn option card is not hot-swappable. Disconnect power to the switch before installing or
removing the Summit XGM-2xn option card. After the Summit XGM-2xn option card is installed in a compatible
switch, XENPAK modules may be hot-swapped into and out of the option card. Use only XENPAK modules approved
by Extreme Networks.
You need the following tools and equipment to install a Summit XGM-2xn option card:
● ESD-preventive wrist strap
● # 1 Phillips screwdriver
CAUTION
Be sure that proper ESD controls are in use before switch maintenance is performed. This includes but is not
limited to wrist straps that are grounded to the switch chassis and earth grounds.
To install the Summit XGM-2xn card:
1 Disconnect the AC power and any redundant power supply from the Summit switch.
2 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the equipment
rack.
3 Remove the screws holding the filler panel over the option slot on the back of the switch (Figure 70).
Remove the filler panel and set it aside. Save the screws for re-use.
Figure 70: Removing the Option Slot Filler Panel
4 Align the sheet metal edges on the option card with the card guides in the switch housing. Carefully
slide the Summit XGM-2xn option card into the switch housing until the connectors engage and the
card is flush with the back panel of the switch (Figure 71).
Table 21: Summit X450 ZR XENPAK Combinations
Left Slot Right Slot
ZR XENPAK Empty
ZR XENPAK SR XENPAK
ES4K041
Filler Panel