Installation guide

Installing Summit External Power Supplies
Summit Family Switches Hardware Installation Guide
100
Figure 68: Securing the EPS-600LS to the EPS-C Chassis
5 Connect the AC power cord to the AC connector on the EPS-600LS unit (see Figure 69).
Use the cable clip on the EPS-600LS unit to hold the AC power cord in place (see Figure 69).
CAUTION
The EPS-600LS unit does not have a switch for turning the unit on and off. Disconnect power to the EPS-600LS
unit by removing the plug from the electrical outlet. Make sure that this connection is easily accessible to you.
Figure 69: Installing the Redundant Power Cord
6 Connect the other end of the AC power cord to the electrical outlet (see Figure 69).
EPS-C_05A
! See Manual
O.T.P
DC OK
AC OK
EPS-600LS
Tighten Screws
! See Manual
O.T.P
DC OK
AC OK
EPS-C_06A
To A C
Power Cord
Cable Clip