Installation Guide
Table Of Contents
- ExtremeRouting SLX 9850-8 Hardware Installation Guide
- Preface
- About this Document
- Device Overview
- Preparing for the Installation
- Mounting the Device
- Initial Setup and Verification
- Initial setup and configuration checklist
- Items required
- Providing power to the device
- Establishing a serial connection
- Configuring a static IP address
- Establishing an Ethernet connection
- Customizing the chassis and host names
- Configuring the DNS service
- Setting the date and time
- Verifying correct operation
- Backing up the configuration
- Powering down the device
- Installing cable management kit
- Monitoring the Device
- Management Modules
- Interface Modules
- Power Supply Modules
- Power supply module overview
- Precautions specific to the power supply module
- Time and items required for removal and replacement
- Removing an AC power supply module
- Inserting an AC power supply module
- Removing a DC power supply module
- Inserting a DC power supply module
- Verifying power supply module operation
- High Voltage Power Supply Unit supporting AC and DC Voltages
- Fan Modules
- Switch Fabric Modules
- Transceivers and cables
- Supported transceivers and cables
- Time and items required
- Precautions specific to transceivers and cables
- Cleaning the fiber-optic connectors
- Managing cables
- Installing an SFP+ transceiver
- Replacing an SFP+ transceiver
- Installing a QSFP28 transceiver
- Replacing a QSFP28 transceiver
- Breakout cables
- Verifying transceiver operation
- Hardware Maintenance Schedule
- ExtremeRouting SLX 9850 Technical Specifications
- System specifications
- Ethernet
- LEDs
- Other
- Weight and physical dimensions
- Environmental requirements
- Power supply specifications (per PSU)
- Power consumption (typical configuration)
- Power consumption (maximum configuration)
- Power consumption (modules) (typical configuration)
- Power consumption (modules) (maximum configuration)
- Data port specifications (Ethernet)
- Serial port specifications (pinout RJ-45)
- Serial port specifications (protocol)
- Memory specifications
- Regulatory compliance (EMC)
- Regulatory compliance (safety)
- Regulatory compliance (environmental)
- Regulatory Statements
- Cautions and Danger Notices
TABLE 25 HV PSU Rating
Type Rated Input Voltage Supported Input Voltage Range
High Voltage DC (HVDC) 240V - 380VDC 192V-400VDC
High Voltage AC (HVAC) 100V - 120VAC, 200V - 277VAC 90V - 132VAC, 180-305VAC
Similar to the AC PSU that is already supported and released, the HV PSU have an integrated fan in it and therefore will need to match
airow of the PSU fan to the base chassis airow. There is only one air direction version and it will intake air from the port side and
exhaust to the non-port side. This PSU is oered to match airow of the chassis. In summary, following are two HV PSU oerings made
available for SLX 9850-4 SLX 9850-8.
TABLE 26 HV PSU
Input Voltage Air-ow Type Input Connector
HV DC, 240V-380V DC
&
HV AC, 100V-120V AC, 200V-277V AC
Intake - NPI SAF-D Type
This PSU is 80+ platinum generating output DC power of 3000W for system usage.
The following gure shows the Input side of the 3000W HV PSU:
FIGURE 56 3000W HV PSU Input Side
1. OUTPUT LED
2. INPUT LED
3. Cover Plate
4. Handle
5. Input Plug SAFD-D
6. Latch of the PSU
High Voltage Power Supply Unit supporting AC and DC Voltages
ExtremeRouting SLX 9850-8 Hardware Installation Guide
106 9035475-02 Rev AA