Installation Guide

Table Of Contents
NOTE
If you are provided an IPv6 prex with a /65 to /128 netmask, assign the addresses according to your network administrator's
direction, and do NOT follow this procedure.
NOTE
SLX platforms without redundant management modules only need to congure the M 1
interface.
To congure IPv6 addresses, perform the following steps:
1. Enter the show system command to know the STACK MAC and the BURNED IN MAC for each MM present in the system.
device# show system
Stack MAC : 60:9c:9f:60:88:00
-- UNIT 0 --
Unit Name : 9850-8
Switch Status :
Hardware Rev :
Up Time : up 21:00
Current Time : 23:08:49 GMT
SLX-OS Version : 17r.1.00
Jumbo Capable : yes
Burned In MAC : MM1[60:9c:9f:46:e2:06]MM2[60:9c:9f:47:10:7a]
Management IP : 10.25.101.4
Management Port Status : UP
The MAC addresses are used to create the IPv6 SLAAC address for the following mapping:
MM1 MAC - IPv6 address for interface M 1
MM2 MAC - IPv6 address for interface M 2
Stack MAC - IPv6 address for chassis virtual-ipv6
Conguring a static IP address
Brocade SLX 9850-8 Router Hardware Installation Guide
53-1004400-05 67