Installation Guide
Table Of Contents
- Brocade SLX 9850-4 Router Hardware Installation Guide
- Preface
- About this Document
- Device Overview
- Preparing for the Installation
- Mounting the Device
- Initial Setup and Verification
- Initial setup and configuration checklist
- Items required
- Providing power to the device
- Establishing a serial connection
- Configuring a static IP address
- Establishing an Ethernet connection
- Customizing the chassis and host names
- Configuring the DNS service
- Setting the date and time
- Verifying correct operation
- Backing up the configuration
- Powering down the device
- Installing cable management kit
- Monitoring the Device
- Management Modules
- Interface Modules
- Power Supply Modules
- Power supply module overview
- Precautions specific to the power supply module
- Time and items required for removal and replacement
- Removing an AC power supply module
- Inserting an AC power supply module
- Removing a DC power supply module
- Inserting a DC power supply module
- Verifying power supply module operation
- High Voltage Power Supply Unit supporting AC and DC Voltages
- Fan Modules
- Switch Fabric Modules
- Transceivers and cables
- Supported transceivers and cables
- Time and items required
- Precautions specific to transceivers and cables
- Cleaning the fiber-optic connectors
- Managing cables
- Installing an SFP+ transceiver
- Replacing an SFP+ transceiver
- Installing a QSFP28 transceiver
- Replacing a QSFP28 transceiver
- Breakout cables
- Verifying transceiver operation
- Hardware Maintenance Schedule
- Brocade SLX 9850 Router Technical Specifications
- System specifications
- Ethernet
- LEDs
- Other
- Weight and physical dimensions
- Environmental requirements
- Power supply specifications (per PSU)
- Power consumption (typical configuration)
- Power consumption (maximum configuration)
- Power consumption (modules) (typical configuration)
- Power consumption (modules) (maximum configuration)
- Data port specifications (Ethernet)
- Serial port specifications (pinout RJ-45)
- Serial port specifications (protocol)
- Memory specifications
- Regulatory compliance (EMC)
- Regulatory compliance (safety)
- Regulatory compliance (environmental)
- Regulatory Statements
- Cautions and Danger Notices
TABLE 21 PS module LED
descriptions (continued)
LED purpose Color Status Recommended action
Check the environmental
temperature.
Interpreting fan module LEDs
Refer to the following illustration and table to interpret the LED patterns on the power supply module. The LED patterns may temporarily
change during device diagnostic tests.
FIGURE 39 Fan and switch fabric module LEDs - Brocade SLX 9850-4
1. Fan LEDs (Top LED - power; Bottom LED - status). 2. Swtch fabric module LED (Top LED - power; Bottom LED - status).
NOTE
There are two sets of LEDs, one for the fan and one for the switch fabric module (SFM). This table describes both sets of LEDs.
TABLE 22 Fan module LED descriptions
LED purpose Color Status Recommended action
Power (Fan) No light (LED is o) Fan assembly does not have power. Ensure that the fan assembly is
rmly seated and has power.
Steady green Fan assembly has power. No action is required.
Status (Fan) No light (LED is o) Fan assembly is either healthy or
does not have power.
Ensure that the fan assembly has
power.
Interpreting fan module LEDs
Brocade SLX 9850-4 Router Hardware Installation Guide
53-1004399-05 83