Installation guide

Installing Sentriant AG
Sentriant AG Software Installation Guide, Version 5.2
14
d Wait. Installation can take a few minutes.
e When installation is complete, remove the CD.
NOTE
If the server reboots before you remove the CD, the boot prompt appears again. Remove the CD and reboot the
server to start Sentriant AG.
f The server reboots and starts Sentriant AG.
2 Install the ES software:
a Perform the steps described in “Creating a Single-server Installation”:
step 1 on page 6 through step 11 on page 12. The Extreme Networks, Inc. Sentriant AG
installation type screen appears (Figure 8 on page 12).
b Select Enforcement server.
c Select ok. The Installation progress screen appears (Figure 9 on page 13).
d Wait. Installation can take a few minutes.
e When installation is complete, remove the CD.
NOTE
If the server reboots before you remove the CD, the boot prompt appears again. Remove the CD and reboot the
server to start Sentriant AG.
f The server reboots and starts Sentriant AG.
3 Add as many ESs as your system requires.
4 Go to “Initial Configuration”.
Initial Configuration
NOTE
If you already have endpoints attached to a switch when you install Sentriant AG, you must log in to each switch
and send the NAC revalidate command before the endpoint can be tested and routed properly.
To configure the Sentriant AG MS/ES:
1 Log into a different computer with browser software installed. The following browsers are supported
for this release:
■ Windows: IE 6.0 or later, Mozilla Firefox v1.5 or later, Mozilla v1.7