Installation guide

Installing Sentriant AG

Sentriant AG Software Installation Guide, Version 5.2

13 Select OK. The Installation progress screen appears (Figure 9).

14 Wait. Installation can take a few minutes.

15 When installation is complete, remove the CD.

NOTE

If the server reboots before you remove the CD, the boot prompt appears again. Remove the CD and reboot the

server to start Sentriant AG.

16 The server reboots and starts Sentriant AG.

17 Log in to the Sentriant AG server and perform the initial configuration as described in “Initial

Configuration” on page 14.

Creating a Multiple-server Installation

To install the MS and ES on different servers:

1 Install the MS software:

a Perform the steps described in “Creating a Single-server Installation”:

step 1 on page 6 through step 11 on page 12. The Extreme Networks, Inc. Sentriant AG

installation type screen appears (Figure 8 on page 12).

b Select Management server.

c Select ok. The Installation progress screen appears (Figure 9 on page 13).

Figure 9: Install Screen, Installation Progress