Installation guide

System Requirements
Sentriant AG Software Installation Guide, Version 5.2
3
NOTE
The hardware and memory requirements for Sentriant AG v5.0 are not the same as older versions. The software will
not prevent you from upgrading; however, you may experience performance issues if your hardware and memory are
less than that specified.
NOTE
It is strongly recommended that you use the server-class Intel NIC cards. If you use a different NIC card, you might
be unable to connect, or experience unpredictable results and availability.
NOTE
Your license key is emailed to you. If you did not receive one, contact Extreme Networks, Inc. Technical Assistance
Center (TAC) ([e-mail] or [phone]).
Specific System Requirements
The following hardware is supported for this version of Sentriant AG, although other hardware may
also function properly:
● Server (hosting Sentriant AG):
The following servers are supported only when used with hardware listed in the Sentriant AG
Installation guide and the Sentriant AG Users’ guide.
■ Dell 1950 Multi-core Intel, 2 GB or higher RAM, with SATA or SAS drives
■ Dell 2950 Multi-core Intel, 2 GB or higher RAM, with SATA or SAS drives
■ HP ProLiant DL360 G5 with SAS drives
■ IBM System x3550 with SAS drives
● NIC card:
■ Intel Pro 100/1000
● HA Bypass Card
■ Niagara 2261 bypass card (PCI-X)
■ Niagara 2265 bypass card (PCIe)
● VPN:
■ Cisco VPN Concentrators
■ OpenSSL VPNs
● Switches:
■ Cisco
4005 CATOS (software version 8.4 (9) GLX)
6509 CATOS (software version 8.5 (7))
2950 IOS (software version 12.1 (22) EA8a)
3750 IOS ipbase 12.2(25) SEB