Specifications

12
Ridgeline Concepts and Solutions Guide
185
Verifying EAPS Information
Ridgeline lets you verify the EAPS configurations in your network, and provides a report that shows
where configuration errors are found.
To run the verification procedure on your EAPS domains, select Verify EAPS domains from the
Protocol menu. Depending on the size of your network and your EAPS configurations, this can take as
long as 15 minutes.
The results of the verification are shown in the EAPS Verification Results window.
Figure 145: EAPS Verification Results Window
If errors are reported, you can log into the affected device(s) to correct the problems. Once you have
corrected any reported errors, you should run the verification again to ensure that the configuration is
correct.
● Click the Refresh button to re-run the verification process.
● Click Save results... to save the verification results to a file.
The following table lists the error types that may be reported by the EAPS verification process:
Table 5: EAPS Verification Error Types
• No Master Node • Inconsistent EAPS Node Naming • No Physical Link
• Multiple Master Nodes • Control VLAN not in QP3 • Domain List Mismatch
• Disabled EAPS Node • Unprotected Shared Link • Link ID Not Configured
• Missing Control VLAN • Duplicate Link ID • Control VLAN Misconfigured
• Missing Primary Domain Port • Missing Link ID • Protected VLAN Misconfigured
• Missing Secondary Domain
Port
• Mismatched Link ID • Shared Port Misconfigured
• Mismatched Domain Ports • Misconfigured Shared Port Mode • Controller Misconfigured