Specifications

ExtremeWare/ExtremeXOS Support Requirements
Ridgeline Service Advisor Release Note 15
NOTE
For the Mozilla Firefox browser, you must install the Java Plug-In, then link the plug-in to the Firefox browser. See
the Ridgeline SA Installation and Upgrade Guide for instructions.
Modifying the Amount of Memory Available for Java Applets
By default, Java applets can consume only up to 64MB of memory. This may not be enough to allow
Ridgeline SA to function effectively. Java applets without sufficient memory may start up and run very
slowly, or may generate an Out of Memory error. You can increase the amount of memory available to
applets through the Java Plug-in control Panel. The following instructions apply to JRE 1.6.0.
To increase the memory available to Java applets, do the following:
1 Go to the Windows Control Panel.
2 Click the Java icon to launch the Java Control Panel.
3 Click the Java tab
4 Under Java Applet Runtime Settings, click the View... button.
5 Double-click the field labeled Java Runtime Parameters, type the following line exactly as shown,
then click OK.
-Xmx256M
6 Click Apply. Restart the browser to have these settings take effect.
ExtremeWare/ExtremeXOS Support Requirements
Table 2 describes the minimum ExtremeWare or ExtremeXOS software image versions for each switch
platform supported in Ridgeline SA release 2.0. Make sure that you have these software images or later
versions running on your Extreme switches before running Ridgeline SA.
Table 1: Ridgeline SA 2.0 Supported Browsers
Platform Minimum Browser Configuration
Microsoft Windows Internet Explorer™ 6.0, 7.0, 8.0; Mozilla Firefox 1.5,
2.0, 3.0
Sun Solaris 10 Mozilla Firefox 1.5, 2.0, 3.0
Red Hat Enterprise Linux 5 Mozilla Firefox 3.0
Table 2: ExtremeWare/ExtremeXOS Versions Supported by Ridgeline SA 2.0
Extreme Switch Platform ExtremeWare Versions Supported
Summit 150 ExtremeXOS 12.0 SR1 or later
Summit 200 7.1e or later
(Note: S200s stacking not supported in 7.1e.
Please upgrade to 7.4
for stacking support).
7.3e or later required for 802.1x and SNMPv3 support
7.4 or later required for S200s stacking support.
Summit 300-24 7.3e or later