Specifications

To configure Ridgeline for multi-homed servers:
1 Stop the Ridgeline server. See Stopping the Server on Windows.
2 Start the Ridgeline Server Setup Utility:
•
On a Windows system, click Start > Programs > Extreme Networks > Ridgeline4.0 > Server setup
utility.
•
On Linux, the server setup utility from symbolic link is in /root/ExtremeNetworks/
Ridgeline4.0/Server Setup Utility.
The Ridgeline Server Setup Utility dialog box appears (see the following figure).
Figure 28: Ridgeline Server Setup Utility Dialog Box
3 Choose one of the setup options:
•
Use this IP address to launch the clients and to talk to the network devices. This selection is not
relevant for a multi-homed system, because it only specifies a single interface for all
communications.
•
Use this host name to launch the clients. If you choose this option, clients should use the
displayed hostname to communicate with Ridgeline. Ridgeline determines which IP address to
use to communicate with network devices.
•
Use this host name to launch the clients. If this is selected, clients should use the displayed
hostname to communicate with Ridgeline, and choose an IP address from the Use this IP address
to talk to the network devices list for network device communication.
4 Optionally, specify a different HTTP port in the Ridgeline's HTTP port box.
5 Click Confirm. A confirmation dialog box appears.
6 Click OK, and then close the setup utility.
7 Start the Ridgeline server (see Starting and Stopping the Ridgeline Server).
Installing the Ridgeline 4.0 Server
Ridgeline Installation and Upgrade Guide 38