User guide

260 ExtremeWarePx1 1.2 Command Reference Guide
Commands for Monitoring the Switch
show port
show port [gigabit | mgmt]
Description
Displays summary information about the speciÞed port.
Syntax Description
Default
N/A.
Usage Guidelines
None.
Example
This example shows summary information for the Gigabit port.
SummitPx1:39 # sh port gig
Port Summary, port 0:
Port State: enabled
Link is UP
Auto negotiation is done
GPCS mode -- Full duplex mode
Auto negotiation is enabled
Full duplex enabled
Packets Received (RX) : total packets received
705327 Unicast, 11 Broadcast, 6751 Multicast, 0 Errors
Packets Transmitted (TX) : total packets transmitted
818772 Unicast, 4539 Broadcast, 0 Multicast, 0 Errors
This example shows summary information for the management port.
SummitPx1:43 # sh port mgmt
Management Port Summary:
Link is UP
Auto negotiation is done
Operating in 100 Base-T Full duplex mode
Auto negotiation is enabled
History
This command was available in ExtremeWarePx 1.1.
gigabit Specifies the Gigabit Ethernet network interface port.
mgmt Specifies the front panel 10/100 management port.