User guide

192 ExtremeWarePx1 1.2 Command Reference Guide
Commands for Configuring Redundancy
disable vrrp
disable vrrp
Description
Disables VRRP on the application switch.
Syntax Description
This command has no parameters or options.
Default
VRRP is disabled by default.
Usage Guidelines
You must have administrator privileges to issue this command.
If VRRP is enabled on two Px-series application switches and you need to disable VRRP on one switch,
you should Þrst make sure that the other switch is either powered down or off the network. Network
issues may arise if you fail to remove the other switch, because both switches will be active on the same
services or gateway-mode IP addresses.
You must use the build command to commit the conÞguration changes made by this command.
Example
The following command disables VRRP.
disable vrrp
History
This command was available in ExtremeWarePx 1.1.
Platform Availability
This command is available on the Px-series application switch.