User guide

Packet Over SONET Module Installation and User Guide A-5
Changed Commands
Changed Commands
Changes to existing ExtremeWare commands fall into two categories:
• Syntax enhancements to support the PoS module
• Implementation changes to support the PoS module
Syntax changes are visible: keywords or arguments may have been added or changed to
make it possible to configure the behavior associated with the PoS module.
Implementation changes may be visible, taking the form of different input behavior,
such as blocking an attempt at specifying a PoS port for a given command, or in
additional information in the results of a command, such as in a
show ports command.
Commands not described in this section are supported by the PoS module as
described in the ExtremeWare Software User Guide.
Table A-2 is an alphabetical list of the existing ExtremeWare commands whose syntax
has been enhanced to support the PoS module. New keywords and arguments are
shown in italic typeface.
unconfig flowstats ports <portlist> Resets the flow statistics configuration
parameters for a specified SONET port to their
default values.
unconfig ppp ports <portlist> Resets the PPP configuration parameters for the
specified ports to their default values.
unconfig sonet ports <portlist> Resets the configuration parameters of the
specified SONET port to their default values.
Table A-2: Summary of Commands with Enhanced Syntax
Command Description
config diffserv examination code-point
<code_point> qosprofile <qosprofile>
ports <portlist> {low-drop-probability |
high-drop-probability}
Added optional keywords for low-drop-probability
and high-drop-probability.
Table A-1: New ExtremeWare Commands (continued)
Command Description