User guide

Packet Over SONET Module Installation and User Guide A-3
New Commands
config flowstats filter <filter#> {aggregation}
{export <group#>} ports <portlist>
[ingress | egress] <filterspec>
Configures a flow record filter for the specified
SONET ports.
config flowstats source ipaddress
<ipaddress>
Configures the IP address that is to be used as
the source IP address for NetFlow datagrams to
be exported.
config flowstats timeout <minutes> ports
<portlist>
Configures the timeout value for flow records on
the specified SONET ports.
config ports <portlist> tunnel hdlc [off | mpls] Enables tunneling for HDLC encapsulated frames
from a SONET port through an MPLS network.
config ppp [bcp [on | off] |
ipcp [on {peer-ipaddress <ipaddress>} | off]]
ports <portlist>
Configures the Network Control Protocol that will
run on the specified PPP ports.
config ppp authentication [off | chap | pap |
chap-pap] ports <portlist>
Configures authentication on the specified PPP
ports.
config ppp delayed-down-time <seconds>
ports <portlist>
Configures the delayed-down-time interval used
by PPP for the specified ports.
config ppp echo [<seconds>
<consecutive_misses> | off] ports <portlist>
Configures the link maintenance protocol on the
specified ports.
config ppp pos checksum [32 | 16]
ports <portlist>
Configures the size of the HDLC Frame Check
Sequence (FCS) to be used on the specified
SONET ports.
config ppp pos scrambling [on | off]
ports <portlist>
Specifies whether the payload data should be
scrambled on the specified ports.
config ppp quality [off |
<required_percent> {<seconds>}]
ports <portlist>
Configures the Link Quality Monitoring (LQM)
protocol on the specified ports.
config ppp user <name> {encrypted}
{<password>} ports <portlist>
Configures the user name and password that the
specified PPP port uses in the event the PPP
peer requests authentication.
config red min-threshold <percent>
ports <portlist>
Configures the minimum queue length threshold
for RED operation on the specified PoS ports.
config sonet clocking [line | internal]
ports <portlist>
Configures the clocking source for the specified
SONET ports.
config sonet framing [sonet | sdh]
ports <portlist>
Configures the framing type for the specified
SONET ports.
config sonet signal label [auto | <hex_octet>]
ports <portlist>
Configures the Signal Label value for the
specified SONET ports.
Table A-1: New ExtremeWare Commands (continued)
Command Description