User guide

Packet Over SONET Module Installation and User Guide 3-101
Additional PoS Module Support Topics
Additional PoS Module Support Topics
This section describes additional command and configuration information related to the
use of the PoS modules. This section includes information on the following topics:
• Configuring General Switch Attributes on page 3-101
• Configuring Port Attributes on page 3-102
• Configuring IGMP Attributes on page 3-105
• Configuring Layer 2 and 3 Switching Attributes on page 3-105
• Configuring Access List Attributes on page 3-106
• Changing Image and Configuration Attributes on page 3-106
Configuring General Switch Attributes
Except as described below, the PoS module supports all of the general ExtremeWare
switch commands. Table 3-17 describes the changes to existing ExtremeWare general
switch commands to support the PoS module. Commands with keywords or
parameters shown in italic typeface are existing ExtremeWare commands that have been
enhanced to support the PoS module.
Table 3-17: Changes to General Switch Commands
Command Description of Change
show slot {<slot>} Augmented implementation: For the PoS
module, the information displayed by this
command will include data about the software
images loaded on the module, as well as network
processor and GPP status.
config slot <slot> module [f32t | f32f | f48t |
g4x | g6x | g8x | g12x | p3c | p12c]
Enhanced command: The p3c and p12c
keywords represent the OC-3 PoS module and
the OC-12 PoS module, respectively.
show version Augmented implementation: The information
displayed by this command will include data
about the PoS module and the bootrom version
of the PoS module.