User guide

3-94 Packet Over SONET Module Installation and User Guide
Configuring the PoS Module
A manual switch is a lower priority request than a forced switch. The following events
can override a manual switch:
• A
config aps manual off command
• A
config aps force working or a config aps force protection command
• A
config aps lockout on command
• A detected Signal Fail or Signal Degrade line condition
This command applies only to SONET ports performing the protection line
function. Also, the settings from this command are not preserved when the
switch reboots.
The following command example configures APS group 1001 to use its working line as
the active line:
config aps 1001 manual working
Resetting APS Group Configuration Parameters
To reset the APS group configuration parameters to their default values, use the
following command:
unconfig aps <group#>
The group# parameter is an integer in the range from 1 to 65535 that identifies a
particular APS group.
This command does not affect the ports that have been added to the APS
group, but does cancel any outstanding
lockout, force, or switch requests.
The following command example resets the configuration parameters of APS group
1001 to their default values:
unconfig aps 1001