Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: Overview
- 2: Hardware Installation
- 3: Basic Configuration Using the Management Interface
- 4: NX-5500 Specifications
- 5: Regulatory Information
- Regulatory Information
- Radio Frequency Interference Requirements - FCC
- Radio Frequency Interference Requirements - Canada
- CE Marking and European Area (EEA)
- Statement of Compliance
- Japan (VCCI) - Voluntary Control Council for Interference Class A ITE
- Korea Warning Statement for Class A ITE
- Chinese Warning Statement for Class A ITE
- Waste Electrical and Electronic Equipment
- Turkish WEEE Statement of Compliance
- End-User Software License Agreement
- China RoHS Compliance
- Regulatory Information
1 Overview
Package Contents
Power Supply Status LEDs
Power Protection
The NX-5500 Series Integrated Services Platform lets you centrally administer networks of up to 512
WLAN Access Points geographically dispersed over small or medium sized enterprise locations. WiNG
Access Points intelligently handle the trac flows, quality of service and security at remotely distributed
locations, while the NX-5500 provides a single point for configuration, policy setting, and remote
troubleshooting. Hotspot configuration, security policy management, and statistics aggregation are all
done by one integrated services platform. This ecient WLAN architecture makes controlling the
network easier, and reduces the hardware expense required to support large networks.
Package Contents
An NX-5500 Integrated Services Platform ships with the following:
•
NX-5500 series Integrated Services Platform
•
Console cable
•
Left (L) Right (R) rack mount bracket assemblies, six M3 screws
•
NX-5500 Integrated Services Platform Installation Guide (this document)
Power Supply Status LEDs
An NX5500 has a power LED on the front of the enclosure for power supply status. The LED
functionality for the power supply is follows:
State
Description
O No power to power supply.
Green Power supply on. Normal operation.
Power Protection
•
If possible, use a circuit dedicated to data processing equipment. Commercial electrical contractors
are familiar with wiring for data processing equipment and can help with the load balancing of these
circuits.
•
Install surge protection. Be sure to use a surge protection device between the electricity source and
the NX-5500.
•
Install an Uninterruptible Power Supply (UPS). A UPS provides continuous power during a power
outage. Some UPS devices have integral surge protection. UPS equipment requires periodic
NX-5500 Integrated Services Platform Installation Guide 7