Specifications

Issues Resolved in ExtremeWare 7.1.0b48
ExtremeWare 7.1.1 Release Notes 63
If you have the system watchdog timer enabled, executing the show fdb port command on an ATM or
PoS port no longer causes the system to reboot (PD2-134826401).
Routing entries with a next hop in the management interface subnet are now correctly removed from
the routing table based on the MGMT port state (PD2-104430127).
On a BlackDiamond 6816, the
run diagnostics extended msm-d command no longer generates a
system test error (PD2-134478009).
If you hot-swap an F48Ti module, system health check errors are no longer generated (PD2-93060119).
Alpine
T3 modules now properly recover from a failover (PD2-119525910).
If you configure two multilink groups to use the same T1 or E1 module, multilink throughput is no
longer degraded slightly (PD2-117966118).
The output of the
show switch command shows PSU A and PSU B correctly (PD2-129291301,
PD2-133156301).
A message similar to the following:
12/06/2002 11:58.28 <CRIT:KERN> Restarted fifo on slot 2
no longer appears in the log for T1 and E1 slots during the initialization of the T1 or E1 modules
(PD2-110059501).
Messages for system health check events are now always logged (PD2-129795601).
When upgrading an Alpine 3802 to full layer 3, ExtremeWare now checks the system ID (SN) for key
generation (PD2-97422994).
Summit
The autopolarity detection configuration is now correctly saved and loaded on the Summit48si
(PD2-118279201).
Load Sharing
If you configure software redundant ports with load sharing, saved configurations now load properly
via TFTP (PD2-130597269).
IP Unicast
BOOTP relay now operates correctly (PD2-147825901).
Multicast
If you use access-profiles to specify another RP for a given multicast group, the local RP now processes
joins and prunes correctly (PD2-116382027).