Specifications

6 ExtremeWare 7.1.1 Release Notes
Contents
Error Messages with Topology Changes 41
The “C” Flag Might Be Permanently Set 41
Mirroring Does Not Mirror STP BPDUs 41
Topology Change Counter Might Continuously Increment 41
Topology Change Affects All Domains that Share Ports 41
Large STPD Configuration Download Might Reboot Switch 41
A Large STP Configuration with 10 Link Transitions 41
Configure Fewer than 4,000 VLANs in an STPD 42
The show stpd ports Output Incorrect After Topology Change 42
802.1w and IGMP Snooping 42
Output of show stpName port detail Command in Hex Format 42
Do Not Re-use VLAN Tags 42
Ensure that a VLAN Contains Active Ports 42
If You Delete a Port from the STPD, You Cannot Add It Through a VLAN 42
The unconfigure stp Command Does Not Clear All Configurations 42
Enabling ignore-bpdu or ignore-stp 42
High Traffic with 120 STP Instances 43
Configuring a VLAN from Vista 43
STP and VLAN Tagging 43
EMISTP and Ingress Rate Shaping 43
Upgrading From an ExtremeWare 6.1.9 (or earlier) Configuration 43
ESRP 43
The disable slot all Command Generates EDP Errors 43
Environmental Tracking on a Chassis with One PSU 43
Large Configurations Might Lock Console when Enabling and Disabling s0 43
Failure of Direct Link Causes Flip 44
ESRP and Ingress Rate Shaping 44
ESRP and Protocol-Based VLANs 44
ESRP and Load Sharing 44
Hot-Swapping a Module with 5,000 ACLs 44
Traffic Convergence Time 44
ESRP PDUs on Ports 44
Multiple ESRP VLANs 44
ELRP 44
ELRP and Ingress Rate Shaping 44
VRRP 45
Backup Transition Creates Duplicate Packets 45
QoS 45
Duplicate Precedence Rules 45
The qosprofile Accepts a Value Greater than 100% 45
Re-Ordering Access List Precedence Numbers 45
Access List FDB Entries not Cleaned Up 45
Access Lists Using the IP Deny Any Rule 45
Access Lists and IP Fragmentation 45
QoS Configuration Bandwidth Parameters 45
Creating Access Lists from Multiple Sessions 46
5,120 Access Lists and SNMP 46
Monitoring QoS and the show port qos Command 46
Bi-Directional Rate Shaping 46