Specifications

Issues Resolved in ExtremeWare 7.1.1b11
ExtremeWare 7.1.1 Release Notes 59
Disable Remote Syslog Before Enabling IPARP Debug-Tracing
With remote syslog enabled, if you configure the IPARP debug-trace to level 2 or higher, the switch
hangs and is rebooted by the watchdog timer. To avoid this, disable the remote syslog prior to
configuring the debug-trace (PD2-110983505).
Documentation
Summit48si LED Behavior Not Correct
The Summit48si LED behavior described in the Consolidated Hardware Guide is not correct
(PD2-170120478). The actual LED behavior is:
Green: link is present , port is enabled
Green blinking: frames are being transmitted and/or received on this port
Off: link is not present or port is disabled
T-Control Requires Full Layer 3 License
Though not mentioned in the Software Licensing section, the T-control feature does require a full layer 3
license.
Issues Resolved in ExtremeWare 7.1.1b11
The following issues were resolved in ExtremeWare 7.1.1b11. Numbers in parentheses are for internal
use and can be ignored. ExtremeWare 7.1.1b11 includes all fixes up to and including ExtremeWare
6.2.2b108 and ExtremeWare 7.0.1b11. For information on those fixes, see the release notes for those
releases.
BlackDiamond
Hitless failover is now supported with the 10GLRi I/O module (PD2-178533101, PD2-176314518).
Hitless failover is now supported on the A3cMi, A3cSi, P3cMi, P3cSi, P12cMi, and P12cSi modules
(PD2-178533103).
If you unconfigure hitless failover, you are not required to save the configuration and reboot the switch
for this to take effect (PD2-178533105).
If you use the address-based algorithm for a CMT load share group, outbound traffic is now distributed
evenly (PD2-160291549).
Summit
Saving the configuration on a Summit48si switch no longer occasionally corrupts the ExtremeWare
software image when writing to flash memory (PD2-174291301, PD2-82335602).