Specifications

Clarifications and Known Behaviors

ExtremeWare 7.1.1 Release Notes 57

Extreme Power Supply Traps

A new object was added “extremePowerSupplyNumber” to the power supply traps. The two RPS traps

will no longer be sent out. Instead the extremePowerSupplyGood and extremePowerSupplyFail traps

will contain the power supply number indicating which power supply has failed (1-7J56T).

DHCP

The DHCP server is not supported as a standalone feature. It is used as part of the Network Login

feature only (1-8SAI6).

Diagnostics and Troubleshooting

Event Condition Command Completion

If you enter an event condition using the show log events command, press the [Tab] key for

command completion, the console displays an “Ambiguous token” message even though the event

condition exists. This occurs when there are additional conditions that also match your entry. If you

press [Return], the correct log is displayed. For example, if you enter

show log events

BGP.Damp.Cfgchg

and press [Tab], the console displays the following (PD2-153433301):

Ambiguous token: BGP.Dampening.CfgChg

"BGP.Dampening.CfgChg", "BGP.Dampening.CfgChgNullDinfo",

"BGP.Dampening.CfgChgNullNew", "BGP.Dampening.CfgChgNullOld",

"BGP.Dampening.CfgChgRt"

Entering q Does Not Quit Diagnostics Display

Entering q to quit the show diagnostics sys-health-check display does not quit the display

(PD2-145117543).

Single MSM Not Taken Offline

If you have only one MSM installed in a BlackDiamond chassis, you configure the system health check

alarm level to

card-down, and eight errors are detected, the MSM is not taken offline. The MSM remains

fully operational (PD2-143167301).

Automatic Memory Scanning Can Trigger Incorrect Reboot Loop Detection

On Summit and Alpine switches, if memory scanning is automatically initiated via the auto-recovery

parameter in the

configure sys-health-check command and the reboot loop detection threshold is 1,

the system might incorrectly detect a reboot loop and come up in minimal mode (PD2-140185601).

Packet Diagnostics Display Backplane Incorrectly

When you run packet diagnostics on the Alpine 3804, the console displays the backplane as slot 5. The

display is wrong: the diagnostics are correctly running on the backplane. The extended diagnostics

console display is correct (PD2-151752701).