Specifications

ExtremeWare 7.1.1 Release Notes 5
Contents
VDSL Modules in a Half-Duplex Link 36
Summit 36
Output of the show log Command 36
The unconfigure switch all Command Clears the Default VLAN from s0 36
Health Check Error Messages 36
Limited Commands Mode 37
Summit48i Redundant PHY 37
Summit48i Single Fiber Signal Loss 37
SNMP Results for Power Sources 37
Summit48si MIB value for Input Power Voltage 37
Command Line Interface (CLI) 37
SNMP Trap Commands Not Supported 37
The show ports mgmt info Output Missing Flags 37
Press [Return] Key Twice With enable temperature-log Command 37
User Sessions Cannot Enable CLI Paging 37
Only US Character Set Supported 37
Switching and VLANs 38
Saving ip-mtu Settings 38
VLAN priority and STP, EDP 38
Default Routes or Static Routes 38
Configuring a Protocol Filter with ‘ffff’ 38
Deleting Protocols from a VLAN 38
MAC Based VLANs and DHCP Relay 38
VLAN to VLAN Access Profiles 38
FDB 38
Duplicate Entry in show fdb Output 38
Cannot Add FDB Entry for Management VLAN 39
Static FDB Entries and Rate-Shaping 39
MAC Security 39
FDB Aging Timer 39
Configure Less Than 400 Ports in a VLAN 39
Load Sharing 39
Autonegotiation 39
Round Robin Load Sharing 39
Port Based Load Sharing on Summit7i 39
Alpine and Cross Module Load Sharing 39
Load Sharing and Specific Ports in a Load Share Group 40
Load Sharing, Software Redundant Ports, and Smart Redundancy 40
Disabling Load Sharing if the Master is Down Generates Error 40
Mirroring 40
Do Not Configure Port Mirroring While Port is Down 40
Mirroring and Multicast 40
Mirroring IP Multicast Traffic 40
Mirroring and Flooding 40
Spanning Tree 40
Disabling STP Might Display Topology Change 40
802.1w Topology Change Might Cause FDB Flush of Edge Ports 41
FDB Not Flushed After Link Failure with RSTP 41
Do Not Configure All Ports in s0 41