Specifications
4 ExtremeWare 7.1.1 Release Notes
Contents
The show log Command Truncates Long Commands 30
The show log Display Truncates Configuration Parsing 30
Do Not Create Single-Character Names 30
Smart Redundancy Enabled in Saved Configuration 30
Microsoft Load Balancing 30
Telnet and the show ports Command 30
The show configuration Output 30
Configure Slots or VLANs Before Uploading a Configuration 30
LACP not Supported 30
Upgrading to ExtremeWare 7.0 and Bi-Directional Rate Shaping 31
Upgrading to ExtremeWare 7.0 and Debug-Trace 31
Upgrading to ExtremeWare 7.0 and OSPF 31
Blank Space in show port info detail Command Output 31
Using an ExtremeWare 7.0 Configuration with an Earlier Image 31
Console Response with a Large Number of ARP Entries 31
Configuring 1000Base-T Ports for 10,000 Mbps 31
The show log chronological Command 31
BOOTP-Dependent Routes in Downloaded Configuration not Created 32
The disable learning Command and Flooding 32
Port Mirroring 32
Port Tag Limitation 32
WinSCP2 Not Supported 32
BlackDiamond 32
Cross-Module Trunking Module Support 32
Cross-Module Trunking and Hitless Failover 33
Master Slot Must Be Active for CMT 33
MSM-3 Log Might Be Out of Chronological Order 33
Source Addresses Might Age Out of FDB 33
Do Not Use Static FDB Entries with CMT 33
Do Not Reboot Immediately After Synchronizing 34
RSVP-TE Path Local End Point VLANs 34
RSVP-TE End Point IP Addresses Are Not Verified 34
Saving Health Check Configuration After Failure Causes Console Crash 34
Diagnostics on MSM-3 with Hitless Failover Causes Failover and Spurious Message 34
Do Not Configure a Port-Based Backplane Algorithm When CMT is Enabled 34
Cross-Module Trunking and ACLs 34
ExtremeWare 7.0 (and Later) Does Not Support xmodem 34
4,000 VLANs on a BlackDiamond 35
E1 Module and the restart port Command 35
PPP Links Through E1 modules 35
Slot Failure Messages During a Broadcast Storm 35
No Image Information Reported to SNMP with One MSM 35
BlackDiamond 6816 MSM C and D Diagnostics Messages not in Syslog 35
Disabling CLI Paging from the Slave MSM64i 35
Limited Commands Mode and the reboot Command 35
The unconfig switch all Command 35
Dynamic Memory Scanning and Mapping Module Support 35
BlackDiamond 6816 MIB Value for Input Power Voltage 36
Alpine 36
Limited Commands Mode 36