Specifications
Clarifications and Known Behaviors
ExtremeWare 7.1.1 Release Notes 37
Limited Commands Mode
When in limited commands mode, links remain active (PD2-99220424).
Summit48i Redundant PHY
When the primary port of a redundant pair is disabled and the link removed, the LED for that port
continues to flash indicating it has a link and is disabled (9239).
Summit48i Single Fiber Signal Loss
The Summit48i is currently not able to detect a single fiber strand signal loss due to the hardware based
Auto Negotiation parameters (10995).
SNMP Results for Power Sources
The inputPower MIB is unable to differentiate between 110 VAC and 220 VAC input on the Summit
series switches when accessing this MIB attribute through SNMP (10870).
Summit48si MIB value for Input Power Voltage
On the Summit48si, the extremeInputPowerVoltage attribute in extremeSytemCommonInfo is shown as
“0” and the extremePowerSupplyInputVoltage in the extremePowerSupplyTable is shown as
“unknown.” These values cannot be obtained from the switch (1-841J1).
Command Line Interface (CLI)
SNMP Trap Commands Not Supported
The disable snmp trap port-up-down port mgmt and enable snmp trap port-up-down port
mgmt
commands are not supported by the CLI. To enable or disable SNMP port-up-down traps on the
management port, use SNMP (PD2-162482918).
The show ports mgmt info Output Missing Flags
The output of the show ports mgmt info command does not display the flags (PD2-156475701).
Press [Return] Key Twice With enable temperature-log Command
You must press the [Return] key twice when entering the enable temperature-log command. If you
only press the [Return] key once, the system does not display the asterisk indicating a configuration
change. The log is correctly enabled by pressing the [Return] key once (PD2-152215201).
User Sessions Cannot Enable CLI Paging
You cannot enable CLI paging when logged in to a user account. It is enabled by default
(PD2-145565305).
Only US Character Set Supported
The CLI supports only the US character set (2-H1OQC).