Specifications

Clarifications and Known Behaviors
ExtremeWare 7.1.1 Release Notes 35
4,000 VLANs on a BlackDiamond
If you configure more than 4,000 VLANs, EDP might crash, causing ESRP to fail (PD2-153821210).
E1 Module and the restart port Command
After you use the restart port command, E1 modules occasionally fail to establish a physical link
(PD2-85857901).
PPP Links Through E1 modules
PPP links through the E1 module are not always re-established after a reboot. To re-establish the PPP
link, use the
restart ports command (PD2-109252301).
Slot Failure Messages During a Broadcast Storm
If you have more than 15 Gigabit Ethernet links between two chassis, all in the same VLAN and
generating a broadcast storm, the system health check records slot failures in the log. When the
broadcast storm stops, the log messages also stop (PD2-117946811).
No Image Information Reported to SNMP with One MSM
If you only install an MSM in slot B of a BlackDiamond 6804, BlackDiamond 6808, or BlackDiamond
6816, no primary or secondary image information is reported to your SNMP NMS (PD2-129612901).
BlackDiamond 6816 MSM C and D Diagnostics Messages not in Syslog
If you run diagnostics on an MSM in slot C or D of a BlackDiamond 6816, messages are not recorded in
the syslog. To view the diagnostics messages, use the
show diagnostics command (PD2-118049501).
Disabling CLI Paging from the Slave MSM64i
Enabling or disabling CLI paging from the slave MSM64i has no affect on the master MSM64i paging
configuration (PD2-104377501).
Limited Commands Mode and the reboot Command
When the BlackDiamond 6816 is in limited commands mode, the reboot command does not reboot
both MSM64i modules; instead the command causes the master MSM64i to fail over (PD2-107053801).
The unconfig switch all Command
If you use the unconfig switch all command and immediately use the config default vlan
delete port all
command, the switch reboots (PD2-105474401). To avoid this situation, after you
unconfigure the switch, wait for the switch to completely reboot before you delete the ports.
Dynamic Memory Scanning and Mapping Module Support
BlackDiamond I/O module memory scanning and mapping support is listed in Table 10.