Specifications

Upgrading ExtremeWare
ExtremeWare 7.1.1 Release Notes 21
You can ignore any diagnostics failure messages generated by the synchronization.
10 Reboot the switch using the
reboot command.
11 If you are using the Network Login campus mode:
a Manually enable Network Login using the
enable netlogin [web-based | dot1x] command.
b Verify that users are able to authenticate and successfully access network resources.
Upgrade ATM, MPLS, ARM, PoS, T1, E1, or T3 Modules
If you are using an ATM, MPLS, ARM, PoS, T1, E1, or T3 module, upgrade the module to ExtremeWare
7.1.1:
1 TFTP download the latest ExtremeWare version for the module using the
download image slot
command.
NOTE
T1, E1, and T3 modules must be using ExtremeWare 6.1.8b79 (or later) and BootROM 2.8 (or later)
before upgrading to ExtremeWare 7.1.1.
2 Reboot the module using the
reboot slot command.
NOTE
If you are upgrading multiple modules, skip step 2 until you have upgraded every module, then
reboot the switch instead of rebooting each slot.
3 Download the BootROM using the
download bootrom slot command.
4 Reboot the module using the
reboot slot command.
NOTE
If you are upgrading multiple modules, skip step 4, upgrade every module, then reboot the switch.
Upgrading an Alpine 3802 to ExtremeWare 7.1.1
To upgrade an Alpine 3802 to ExtremeWare 7.1.1:
1 Upload the configuration to your TFTP server using the
upload configuration command.
2 Upgrade to BootROM 8.1 using the
download bootrom command.
3 Reboot the switch using the
reboot command.
4 TFTP download ExtremeWare 6.1.8w3.0.1 b79 to the primary image space using the
download image
primary
command.
5 Verify that the correct BootROM and ExtremeWare versions are loaded on the switch using the
show
switch
and show version commands.
6 Answer
y at the prompt to reboot the switch.
7 TFTP download ExtremeWare 7.0.0b46 to the primary image space using the
download image
primary
command.
8 Reboot the switch using the
reboot command.