Specifications

20 ExtremeWare 7.1.1 Release Notes
Upgrading to ExtremeWare 7.1
3 Verify that the correct BootROM and ExtremeWare version are loaded using the show switch and
show version commands.
4 TFTP download the saved configuration, and answer
y at the prompt to reboot the switch.
5 Check the log for configuration errors. Manually enter configurations that did not load.
6 Save the configuration.
Do not save to the secondary configuration space until you are certain a downgrade to the previous
image is not required.
NOTE
After upgrading from ExtremeWare 6.1.9 to ExtremeWare 6.2.2, the IGMP snooping leave time-out
value will be changed from 10 seconds to 0. This results in an IGMP snooping membership entry
being removed immediately when an IGMP leave is received from a host.
This is good for an environment where only one host is connected. Use the
configure igmp
snooping leave-timeout
command to change the leave time-out value back to 10 seconds.
Upgrade to ExtremeWare 7.1.1
If you are running ExtremeWare 6.2.2b56 (or later), upgrade to ExtremeWare 7.1.1:
NOTE
If you are upgrading a chassis with MSM64i’s to MSM-3’s, see the MSM-3 Upgrade Note included with
your MSM-3.
1 Upload the configuration to your TFTP server using the
upload configuration command.
2 Clear your switch using the
unconfigure switch all command, and enter y at the prompt to
reboot the switch.
3 TFTP download ExtremeWare 7.1.1 to the primary image space using the
download image primary
command.
4 Reboot the switch using the
reboot command.
NOTE
If you have Hitless Failover enabled on your MSM-3, you can use the hitless upgrade procedure.
5 Verify that the correct ExtremeWare version is loaded on the switch using the
show switch
command.
6 TFTP download the configuration you saved in Step 1, and enter
y at the prompt to reboot the
switch.
7 Check the log for configuration errors. Manually enter configurations that did not load.
8 Save the new configuration to the primary space.
Do not save to the secondary configuration space until you are certain a downgrade to the previous
image is not required.
9 If you are upgrading a BlackDiamond switch, synchronize the BootROM, image, and configuration
across all installed MSM modules using the
synchronize command. This command reboots the
synchronized modules.