Manualshelf

Installation Guide

ManualsBrandsExtreme Networks ManualsComputers & AccessoriesMultiservice IP/MPLS Core, WAN Edge, Border Router, IPSec Router and Network Packet Broker
31323334353637383940
26 Brocade MLX Series and Brocade NetIron XMR Installation Guide
53-1004195-02
Router modules
100/1000 Ethernet ports
The 100/1000 Ethernet interface module contains 20 physical ports, through which you can connect your router to other network routers
at a speed of 100 Mbps or 1 Gbps.
You must insert an SFP-compliant fiber-optic transceiver (provided by Brocade) into a physical port. SFP-compliant fiber-optic
transceivers provide a physical medium-dependent (PMD) fiber interface that can be used with either the LAN physical layer (PHY) or
WAN physical layer (WAN PHY).
For a list of SFP optics supported by Brocade, refer to the latest version of the Brocade Optics Family Data Sheet, available online in the
following location:
http://www.brocade.com/downloads/documents/data_sheets/product_data_sheets/optics-family-ds.pdf
20-port 10/100/1000 Ethernet interface module
<Link>Figure 21 shows the front panel of the 20-port 10/100/1000 Ethernet RJ45 module.
FIGURE 21 20-port 10/100/1000 copper Ethernet interface module front panel
The front panel includes the following features:
• LEDs
• Twenty 10/100/1000 copper Ethernet ports.
<Link>Table 13 describes the 20-port 10/100/1000 Ethernet module LEDs.
NI-MLX-1Gx48-T-A interface module
<Link>Figure 22 shows the front panel of the NI-MLX-1Gx48-T-A interface module.
TABLE 12 20-port 100/1000 Ethernet module LEDs
Position State Meaning
Below each Ethernet port.
(Left-side LED supports port in
top row. Right-side LED
supports port in bottom row.)
On or blinking The port is transmitting and receiving packets.
Off for an extended period The port is not transmitting or receiving packets.
TABLE 13 20-port 10/100/1000 Ethernet module LEDs
LED Position State Meaning
Link or
Active
Above the ports. The top
port LED is on the left side,
the bottom port LED is on
the right side.
On (solid) A link is established with the remote port (with no traffic).
Blinking The port is transmitting and receiving packets.
Off A link is not established with the remote port and no traffic is
being passed.