Manualshelf

Installation Guide

ManualsBrandsExtreme Networks ManualsComputers & AccessoriesMultiservice IP/MPLS Core, WAN Edge, Border Router, IPSec Router and Network Packet Broker
281282283284285286287288289290
Brocade MLX Series and Brocade NetIron XMR Installation Guide 273
53-1004195-02
Replacing fan assemblies
DRAFT: BROCADE CONFIDENTIAL
Attaching the upward deflector
The upward deflector is placed between the fan assembly handle and the fan assembly faceplate. To install the upward deflector to each
fan assembly, complete the following steps:
1. Using a Phillips screwdriver, detach the fan assembly faceplate by removing the three screws from each side of the fan
assembly. Refer to Figure 161 on page 267.
2. If present, remove and discard the tape that stabilizes louvers in some fan assembly models. When present, the tape is located
on the right and left sides of the fan assembly.
FIGURE 167 Removing the fan assembly faceplate
FIGURE 168 Removing tape from the fan assembly
3. If louvers are present inside the fan assembly faceplate, detach them by removing the 11 roll pins that secure the louvers to the
inside of the fan assembly faceplate.
NOTE
Legacy Brocade MLX-32 fan assemblies may have louvers. Louvers are not present in newer Brocade MLX-32 fan assemblies.