Manualshelf

Installation Guide

ManualsBrandsExtreme Networks ManualsComputers & AccessoriesMultiservice IP/MPLS Core, WAN Edge, Border Router, IPSec Router and Network Packet Broker
271272273274275276277278279280
Brocade MLX Series and Brocade NetIron XMR Installation Guide 259
53-1004195-02
Replacing a power supply
DRAFT: BROCADE CONFIDENTIAL
FIGURE 155 Removing and replacing a power supply in a 32-slot device.
4. Insert the new power supply into the empty power supply slot, using the guides provided on either side of the slot.
Carefully follow the mechanical guides on each side of the power supply slot and make sure the power
supply is properly inserted in the guides. Never insert the power supply upside down.
5. After you insert the power supply, push gently on the power supply faceplate until the power supply is fully seated.
6. Pull up on the handle on the power supply faceplate to lock the power supply in place.
7. For a 4-slot device only, use the screwdriver to secure the two screws on either side of the power supply faceplate.
8. For a 2400W DC power supply only, crimp the #4 AWG power supply wire in the power lugs.
1 Power supply indicators 6 Latch handle locked
2 AC OK 7 Power supply blank cover
3 DC OK 8 Pull down on plunger to remove
4 ALM 9 Power supply
5 Latch handle open