Manualshelf

Installation Guide

ManualsBrandsExtreme Networks ManualsComputers & AccessoriesMultiservice IP/MPLS Core, WAN Edge, Border Router, IPSec Router and Network Packet Broker
171172173174175176177178179180
Brocade MLX Series and Brocade NetIron XMR Installation Guide 159
53-1004195-02
Installing a NetIron XMR 16000 router
DRAFT: BROCADE CONFIDENTIAL
FIGURE 112 Installing a power supply in a NetIron XMR 16000 router
Carefully follow the mechanical guides on each side of the power supply slot and make sure the power
supply is properly inserted. Never insert the power supply upside down.
4. Push the power supply faceplate toward the back of the router until the power supply connector engages the backplane
connector and the latch pin clicks into place.
For information about connecting power to the router, refer to “Connecting AC power”below. For information about powering on the
system, refer to “Activating the power source” on page 185.
Connecting AC power
AC power is supplied through a power cord connected to the power supply installed in the NetIron XMR 16000 router.
Follow these steps to connect the AC power source.
1 Power supply 2 Release latch
1
2