Installation Guide

Brocade MLX Series and Brocade NetIron XMR Installation Guide 127
53-1004195-02
Installing a NetIron XMR Router
This chapter describes how to install a NetIron XMR router and its modules in the following sections:
• “Installation precautions” on page 127
• “Installing 2x100GbE interface modules in NetIron XMR routers” on page 130
• “Installing a NetIron XMR 4000 router” on page 133
• “Installing a NetIron XMR 8000 router” on page 142
• “Installing a NetIron XMR 16000 router” on page 152
• “Installing a NetIron XMR 32000 router” on page 162
• “Attaching a management station” on page 184
• “Activating the power source” on page 185
• “Verifying proper operation” on page 186
The illustrations in this chapter display how to correctly insert the modules and routers. For a complete router module description and slot
number identification, refer to “NetIron XMR routers” on page 6 of this guide.
NOTE
Illustrations in this chapter may differ slightly from the actual equipment.
Installation precautions
Before proceeding, please read all cautions and danger notices for installing NetIron XMR routers.
General precautions
Follow these general precautions when installing a NetIron XMR router.
The procedures in this manual are for qualified service personnel.
If the installation requires a different power cord than the one supplied with the router, make sure you
use a power cord displaying the mark of the safety agency that defines the regulations for power cords in
your country. The mark is your assurance that the power cord can be used safely with the router.
All fiber-optic interfaces use Class 1 Lasers.