FIPS Security Seal Procedures for Brocade MLXe Series Brocade NetIron CES 2000 Series and Brocade NetIron CER 2000 Series

6 of 18 FIPS Security Seal
Publication Number: 53-1002118-01
Applying seals to a Brocade MLXe-4 device
Use the figures in this section as a guide for security seal placement on a Brocade MLXe-4 device. Each
Brocade MLXe-4 device requires the placement of 14 seals:
 Front: Affix one seal from the top of the Management Module (MM) to the front panel of the chassis. Affix
nine more seals—one from each module to the front panel of the chassis. See FIGURE 1 for correct seal
orientation and positioning.
 Rear: Affix four seals from the top panel of the chassis covering a portion of the fan unit lip. You must bend
these seals to place them correctly. See FIGURE 2 for correct seal orientation and positioning.
FIGURE 1 Front view of a Brocade MLXe-4 device with security seals
6
2
1 to 10 = FIPS security seals
5
4
3
7
9
10
8
1