Installation Guide

ports or two 10Gb ports and two stack ports. In the latter configuration, an additional license would
be required for the 10Gb non-stacking ports.
• Two 1GbE copper combination ports that can be upgraded to 10Gb Ethernet.
• Ethernet management port (10/100/1000BASE-T).
• Serial console port implemented as an RJ45 connector used to connect a terminal and perform local
management.
• One front panel USB 2.0 port, operational on switches running ExtremeXOS version 22.2 or later.
• One rear redundant power supply connector.
Figure 26: ExtremeSwitching X440-G2-48p-10GE4 Front Panel
1 = Stack number indicator
4 = 10/100/1000BASE-T ports
2 = Console port/Ethernet management port 5 = 1GBASE-X SFP combination ports
3 = USB port (active with ExtremeXOS version 22.2 or later)
Figure 27: ExtremeSwitching X440-G2-48p-10GE4 Rear Panel
1 = SFP Ports upgradeable to 10GBASE-X
4 = Redundant power input
2 = 1GBASE-T combination ports upgradeable to 10GBASE-T 5 = Grounding lug
3 = AC power input socket
ExtremeSwitching X440-G2-24t-10GE4-DC Switch Ports and Slots
The ExtremeSwitching X440-G2-24t-10GE4-DC switch ports and slots include:
• 24 front panel ports of 10/100/1000BASE-T (RJ45). Both half-duplex and full-duplex
communication are supported on ports 1 through 16. Ports 17 through 24 are full-duplex only.
• Four unpopulated front panel 1GBASE-X SFP combination ports.
ExtremeSwitching X440-G2-24t-10GE4-DC Switch
Ports and Slots ExtremeSwitching Switches
40 ExtremeSwitching Hardware Installation Guide