Installation Guide

Table Of Contents

4. Secure the port extender to each post with rack-mounting screws (not provided).

5. Connect the LAN/Ethernet cables to the extender.

6. When power is connected, verify that the SYS LED on the port extender turns green.

Installing a V300-8P-2T-W Model in a DIN Rail Mount

You need the following tools and materials to install a V300 Virtual Port Extender to a DIN Rail mount:

• ESD-preventive wrist strap

• M4 #2 Phillips screwdriver (magnetic screwdriver recommended)

There are two DIN Rail mounting options. To install a V300-8P-2T-W model in a DIN Rail Mount:

1. Remove all contents of the DIN Rail Mount Kit (XN-DIN-MT-V300).

2. For option 1, attach the DIN mounting bracket to the rear of the port extender using the two screws

(included) for each bracket:

Figure 254: DIN Rail Mounting Option 1: Attach the Bracket

Installing a V300-8P-2T-W Model in a DIN Rail Mount

Installing Expansion Modules

314 ExtremeSwitching Hardware Installation Guide