Installation Guide

Table Of Contents

2. For non-PoE models, after attaching the PSU bracket to the V300, attach the PSU(s) to the PSU

mounting brackets using two cable ties:

Figure 242: V300-8P/8T-2X VESA Mounting with PSU

3. Connect the LAN/Ethernet cables to the extender.

4. When power is connected, verify that the SYS LED on the port extender turns green.

Install a V300 in a Single Rack Mount

The following tools and materials are required to install a non-PoE V300 Virtual Port Extender to a

single rack mount:

• ESD-preventive wrist strap

• M4 #2 Phillips screwdriver (magnetic screwdriver recommended)

• XN-2P-RMTKIT-1CS-001 - Single rack mount kit

1. Remove all contents of the single rack mount kit (XN-2P-RMTKIT-1CS-001).

2. Attach the short and long ear brackets to the V300 using the screws provided.

3. Secure the bracket ﬂanges to the rack using the customer-provided screws appropriate for the rack

you are using.

Install a V300 in a Single Rack Mount

Installing Expansion Modules

304 ExtremeSwitching Hardware Installation Guide