Installation Guide

Table Of Contents

Figure 230: RPS Cable and AC Power Cord Connections for the STK-RPS-1005PS

1 = STK-RPS-1005PS power supply

7 = AC power outlet with ground connection for switch

2 = Switch 8 = Redundant power supply connector on power supply

3 = RPS cable 9 = Redundant power supply connector on switch

4 = RPS AC power cord 10 = AC connector on power supply

5 = Switch AC power cord 11 = AC connector on switch

6 = AC power outlet with ground connection for power

supply

1. Connect one end of the RPS cable (3) to the RPS connector at the rear of the power supply (8).

2. Connect the other end of the RPS cable (3) to the RPS connector on the switch (9).

Note

AC power cords and outlets vary depending on country. See Selecting Power Supply

Cords on page 484 for more information.

Connecting the RPS Cable and AC Power Cord to an

STK-RPS-1005PS Installing External Power Supplies

290 ExtremeSwitching Hardware Installation Guide