Installation Guide

Table Of Contents

Each switch should be connected to a management console – a terminal or PC with terminal-emulation

software. For all Extreme Networks switches, the terminal or PC must be conﬁgured with the following

settings:

• Baud rate: 115200 (for X465, X590, X690, or X870) or 9600 (for other models) (see note)

• Data bits: 8

• Stop bit: 1

• Parity: None

• Flow control: XON/XOFF

Note

Set the baud rate to 115200 when using the RJ45 Ethernet management port on an X465,

X590, X690 or X870 series switch.

For information about setting the proper values, refer to the documentation supplied with the terminal

or PC.

Ensure that the connection between the switch and the management console is over either an RJ45-to-

serial adapter or a DB9 serial cable. Appropriate cables are available from your local supplier, or you can

make your own. To ensure the electromagnetic compatibility of the unit, use only shielded serial cables.

For connector pinouts associated with the console port, see Console Connector Pinouts on page 476.

Logging in for the First Time

After your switch has completed all power-on self-tests, it is operational. Before logging in, verify that

the switch LEDs are on (solid green or blinking green) and that it is connected to a management

console as described in Connecting a Switch to the Management Console on page 260.

To perform the initial login and complete initial conﬁguration tasks, follow these steps.

1. Using a terminal emulator such as PuTTY or TeraTerm, connect to the switch using the serial port

connection.

Be sure that your serial connection is set properly:

• Baud rate: Baud rate: 115200 (for X465, X590, X690, or X870) or 9600 (for other models) (see

note)

• Data bits: 8

• Stop bit: 1

Note

Set the baud rate to 115200 when using the RJ45 Ethernet management port on an X465,

X590, X690 or X870 series switch.

2. At the management console, press [Enter] one or more times until you see the login prompt.

Installing Your Extreme Networks Switch

Logging in for the First Time

ExtremeSwitching Hardware Installation Guide 261