User guide

Screen/Pane Description
ACLs on device Displays the ACLs that are currently available on the switch.
Create Dynamic ACL Displays an template on which to create an ACL. (See the following procedures.)
Help Contains interactive lists of Match Conditions, Actions, and Action Modifiers used to create
an ACL.
Creating ACLs
To create an ACL:
1 Click the Create button to display a new ACL template in the Create Dynamic ACL pane.
2 Replace <ACLrulename> with a name.
3 In the template, click in <match-conditions> and then click one of the March Conditions listed
in the Help pane.
The selection is inserted into the template.
4 Repeat for the other elements as necessary.
5 Click the Save ACL button.
The new ACL is saved and added to the ACLs on device pane.
Applying ACLs to Interfaces
To apply an ACL to an interface:
1 In the ACLs on device pane, click the ACL to be applied.
The Bind ACL command button is enabled.
2 Click the Bind ACL button. The Apply <ACL name> on interface pane is displayed.
3 Click one of the three interface radio buttons (Any, Ports or Vlans). The appropriate fields for the
particular interface are displayed and enabled. (See the figure below.)
Clicking Any disables the other controls in the pane.
Clicking Ports displays a list of all ports on the device. You can choose one or more ports.
Clicking Vlans displays a text box. Enter a VLAN name in the box.
If there are other ACLs applied to the chosen interface, you can apply the new ACL as either the
“first” or “last” ACL or position it before or after an ACL that is already applied to the interface. If the
ACL is already applied to the chosen port or VLAN, all controls are disabled.
4 Make the selections and Save.
The ACL is applied to the interface(s) and the details are displayed in the Interfaces applied to pane.
Point to the ACL to display a tooltip showing the interface status.
Removing ACLs
First unbind the ACL from the interface, if appropriate, and then remove it from the device.
Configuration
ExtremeXOS ScreenPlay User Guide 25