Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.4.2 Release Notes
91
PD4-822468466,
PD4-803423872
An overheated SummitStack fails, but the ports remain active and traffic continues to be
forwarded.
PD4-804569955,
PD4-707855726
The configure inline-power budget command is not supported on Summit family
and SummitStack switches.
PD4-817417079,
PD4-623659132
After a SummitStack failover, the new master node is not reachable using an alternate IP
address or gateway.
PD4-977977546,
PD4-950113401
Clients connected to a non-master slot in a SummitStack cannot communicate with an
ExtremeXOS switch when a port is part of a PVLAN subscriber VLAN, as well as a regular
VLAN.
ACL
PD3-126824622 If an IPv6 address is included in a configuration, use ICMPv6 for the protocol. ICMP
(IPv4) should not be allowed.
PD4-806088533,
PD4-738207292
Access-profile configurations for SNMP and SSH modules are not available in the show
configuration command output.
PD4-806088577,
PD4-641467077
The telnetd process crashes with signal 11 when the same policy file is used in a telnet
access-profile and an ACL.
PD4-826754811,
PD4-667212313
If the refresh policy command is invoked by adding more entries to the policy file,
then after unconfiguring that specific ACL, an ExtremeXOS switch starts logging messages
such as:
Denied packet on ingress interface vlanIf=1000223 slot=1 port=1,
too many ACL's & packet rate is too high" and start to drop all
the packets received in slow path.
PD4-828768941,
PD4-556797775
The show access-list meter ports x command returns all meters on the switch,
not just the one associated with port x.
PD4-964769277,
PD4-963068135
An ExtremeXOS switch reboots with memory depletion for a 128 memory block while
loading a flow-redirect configuration.
PD4-962772436,
PD4-852494655
With CLEAR-Flow enabled, CLEAR-Flow ACL threads may be killed by EPM.
PD4-983613148,
PD4-670315790
When configuring egress ACLs on a load-shared port the following incorrect error message
is displayed:
Duplicate ACL config, Note: Egress ACL need be applied on the
Master port only
BGP
PD4-1142713461,
PD4-1108149831
The Route Manager crashes when a VLAN through which a network is configured goes
down when using the configure bgp add network command.
PD4-486115891 A Border Gateway Protocol (BGP) speaker is not advertising the inactive multicast routes
when they become active.
DHCP
PD4-1101780701,
PD4-727955846
DHCP OFFER and DHCP ACK packets are duplicated in a VLAN aggregation setup if a
DHCP request is received on a subVLAN.
PD4-804570175,
PD4-717000351
An error message should be displayed when adding a subVLAN to a superVLAN if DHCP
client or BOOTP client is enabled on the subVLAN.
EAPS
PD4-826755051,
PD4-682475164
IPv6 neighbor discovery packets sent to the CPU are affecting EAPSv2 PDUs, resulting in
the following message:
EAPS Shared Port: Segment timer expired.
PD4-874500533,
PD4-861919266
Expected traffic convergence time for EAPS has increased after upgrading from
ExtremeXOS 11.6 to ExtremeXOS 12.0, resulting in more traffic loss.
Table 44: Platform-Specific and Feature PDs (Continued)
PD Number Description